Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 143
disable
Use the disable command to exit the Enable mode and enter the Basic mode.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example exits the Enable mode and enters the Basic Command mode:
#disable
>
To Next Page
Loading...
