Command Reference Guide T1 Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 613
remote-loopback
Use the remote-loopback command to configure the interface to respond to loopbacks initiated by a
remote unit (or the service provider). Use the no form of this command to disable this feature.
Syntax Description
No subcommands.
Default Values
By default, all interfaces respond to remote loopbacks.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example enables remote loopbacks on the T1 interface:
(config)#interface t1 1/1
(config-t1 1/1)#remote-loopback
To Next Page
Loading...
