There are two types of learn processes, hand feed and automatic feed. Hand feed is used when there is a small
sample of products that are not running continuously at the moment. They may be later during production. An
example would be hams. The production line will run continuous hams, but you only have one. In this case
you would select “HAND FEED” even though it will be continuous later. Automatic feed is when there is a
continuous line uninterrupted line of products. This learn method allows a hands-off learn. A continuous
pipeline of liquid or a uninterrupted line of candy bars would be appropriate for this method. Instructions for
both methods are described below.
HAND FEED LEARN/RELEARN: The learn screen gives instructions to pass the product through the
opening. It also shows which product is selected at the time.
After selecting “HAND FEED” the following screen will appear:
Do not place anything in the opening when this screen is visible. After a few seconds this screen will be
replaced by the following screen:
To Next Page
Loading...