ADDITIONAL FEATURES
DATE/TIME SET-UP
The metal detector has an internal "real-time" clock that keeps track of the current date and time. It is set at the
factory and normally would not need to be adjusted. However, to compensate for different time zones and for
changes in Daylight Savings Time, etc. it can be adjusted by going to MENU / LEVEL 3 / PASSWORD /
MAINTENANCE / MORE MAINT OPTIONS / CHANGE DATE TIME
PRINT/REPORT FUNCTIONS
Event list - The metal detector maintains a file named the “DATA LOGGER”. The log keeps track of all events
that affect the metal detector operation. This list can be accessed at any time by simply plugging into the USB
port on front of the detector and downloading the file to a laptop computer. The data log can be cleared by
going to MENU / LEVEL 3 / PASSWORD / REPORTS or by using the shortcut key “Reports” to the left of
the control panel.
CONTRAST ADJUST
The contrast of the metal detector display can be adjusted by going to MENU / LEVEL 3 / PASSWORD /
MAINTENANCE / MORE MAINT OPTIONS / DISPLAY ADJUST.
DETECT COUNTER
The detect counter is used to indicate the number of times metal has been detected since the counter was last
reset. Reset the counter during product changeover for more accurate product run information. To reset the
counter go to MENU / LEVEL 3 / PASSWORD / REPORTS / CLEAR DETECT COUNTER
MAINTENANCE MENU
The maintenance menu allows the user access to the system settings that do not normally need to be adjusted. It
can be reached by MENU / LEVEL 3 / PASSWORD / MAINTENANCE. It can also be reached by using the
shortcut key “System Settings” on the left side of the control panel. The items on the maintenance menu are;
OFFSETS D, E, F & G. These levels should not be changed by the user unless instructed to do so by the
factory. Another item, the “Learn Threshold” sets the sensitivity of the metal detector during the “Learn”
function. This should not be changed without consulting the factory.
The “Learn Timeout” adjustment sets the amount of time that the detector will continue to look for signals
coming from the product during the “Learn” function. If there is not a detectable signal before the countdown
reaches zero, the detector assumes that the product does not generate a signal and will default to the most
sensitive settings for dry products The button marked “More Maintenance” will lead to a second maintenance
menu to set date/time, adjust display contrast, etc.
To Next Page
Loading...