Advanced Elements ATTACK PRO - Inflation Procedure

Attack
TM
Pro Inatable Kayak Owner’s Manual
9
3.3 INFLATION
IMPORTANT: Inate your kayak in the following order. Failure to follow these instructions
may cause damage to your kayak. Do not over inate. Be sure to read directions on operating
the valves in the section “Understanding Your Valves”.
1. Attach thigh straps to front d-rings located in bailing wells and rear d-rings located on side
walls directly behind kayak seat.
2. Insert foot brace tracks into webbing mounting pockets located on kayak main chambers
before ination. Orient each of the foot pegs so that the adjustment tab on the foot plate is facing
towards the bow of the kayak. First insert the foot peg track into the webbing loop nearest to the
seating area and then insert the other end of the track into the webbing pocket at the bow of the
kayak. (See Figures, Steps 1-4 on next page).
3. Check to be sure all 3 valve plungers are in the UP or Inate position. (See Figure 1).
4. Using the adaptor located in your repair kit, inate Main Chamber 1 until rm to the touch
(2.25 psi ONLY).
5. Inate Main Chamber 2 until rm to the touch (2.25 psi ONLY).
6. Inate Floor Chamber “3” until rm (4-6 psi MAX).
7. Make sure all valves are closed tightly and properly.
8. Attach kayak seat and adjust for desired support.
9. Adjust foot pegs for desired bracing by depressing the tabs on the foot plates and sliding along
tracks.
Full-Time Self-bailing
PUSH IN CENTER STEM
WITH FINGER & TURN
Foot Brace Location