Advanced Elements STRAITEDGE ANGLER PRO - Page 17

StraitEdge
TM
Angler PRO Inatable Kayak Owner’s Manual
17
PROBLEM
The tube is kinked
or bent in:
The kayak is not self
bailing:
There is water in the
kayak:
The kayak drifts to one
side:
The kayak does not track
well:
SOLUTION
The tube just needs to be adjusted. When kayak is fully deated try
adjusting the position of the tube inside of the outer shell. Then
reinate.
There are four port holes under each side of the kayak. The port holes
have caps so it can be used as a self-bailing or a dry kayak. Make sure
the caps are o.
There will almost always be a little water in the kayak. One reason
is the water drips o of the paddle and into the kayak. The kayak is
a self-bailing kayak. There are four port holes under each side of the
kayak. The port holes have caps so it can be used as a self-bailing or a
dry kayak. Make sure the caps are on.
A kayak will always head in the direction of your last stroke. Make
sure to check that the air bags in the bow and stern are properly
inated and that the straps are pulled tight. If the oor bladders is not
completely inated, this will also cause the kayak to drift.
Try moving your seat forward a little more. This will allow for better
weight distribution and better tracking.