Advanced Elements STRAITEDGE ANGLER PRO - Assembly, Inflation, and Deflation Instructions; Kayak Assembly Steps

StraitEdge
TM
Angler PRO Inatable Kayak Owner’s Manual
7
Bow and Stern Design
The bow and stern have removable ribs of high-grade aluminum. When the chambers are inated,
these ribs press against the outer cover and form a high performance bow and stern.
3. ASSEMBLY/INFLATING/DEFLATION INSTRUCTION
The StraitEdge
TM
Kayak has a rigid frame in the bow and stern that enhances its performance.
3.1 ASSEMBLY
1. Insert aluminum Bow rib and the Stern rib into the webbing slots on the StraitEdge™ air bags
and webbing slots on the kayak oor, at the bow and stern.
2. Attach air bags to the outer cover by tightening the “air bag compression straps” and buckling
the “air bag buckle”. Do this while the air bag is deated. These are preset at the factory and
may not require any adjustment.
3. Attach the adjustable seat to the StraitEdge™ Angler side tubes by fastening the buckles and
clipping the steel snap hooks to the d-rings behind the seating area.
Front and Rear Bungee
Deck Lacing
AirFrame PRO
TM
Seat
Molded Rubber
Carry Handle
Hard edge bow
for improved
tracking
StraitEdge
TM
System
Drop-Stitch Floor
Spring
TM
Valve
Stainless Steel D-Rings for Drift
Anchor and Stringer Attachment
Removable Tracking
Fin
Front and Rear Accessory
Frame System
Self Bailing Ports
Paddle Holder