Advantage Controls MegaTron - Timer Configuration; Timer Type Selection; Timer Set Up and Pulse Timer

20
4.1 Timer Type Selection
A pop-up screen lets you scroll through the various timer types available.
Pulse - A water meter activated timer
Limit - Feed with bleed with a maximum run time or limit
for one bleed cycle.
Percent - A continuous cycle timer that sets a percentage
On time of a cycle.
Percent Post Bleed - For feed after bleed for a settable
percentage of the bleed time with a maximum run time.
28-Day - A biocide or event timer.
4.2 Timer Set Up
Each timer type selected will have its own unique Set Up
sub menu with additional selections specic to the type
of timer selected. The page displayed before entering
the Set Up menu of a timer provides an overall review
of the timers current settings.
4.3 Pulse Timer
ACCUMULATE - The number of gallons or liters from
water meter to count before activating timer.
RUN TIME - The amount of time for the timer to run
METER INPUT - Select water meter 1 or 2 for the
timer’s activation. Water meter 1 + 2 can be selected
only if the meters have the same contact value.
BLEED INTR - Allows the pulse timer to be interrupted
during conductivity bleed. While interrupted, you can
also dene the maximum number of timer run cycles
(1-9) to store for playback.
4.4 Percent Timer
% of CYCLE - The percent of the dened cycle time
that the timer is to be on.
CYCLE TIME - The amount of time in MM:SS that the
cycle is going to be on.
>SYSTEM 1 TIMER 1 SET UP<
>SET TIMER TYPE (PULSE)<
-> PULSE
USE UP/DOWN KEYS TO CHANGE
PRESS ENTER TO ACCEPT
SET UP TIMER TYPE
>SYSTEM 1 TIMER 1 SET UP<
TIMER TYPE: PULSE
GALLONS: 10
RUN TIME (MM:SS): 01:00
INPUT: WATER METER 1
SET UP TIMER TYPE
>SYSTEM 1 TIMER 1 CHANGE<
ACCUMULATE
RUN TIME
METER INPUT BLEED INTR
>SYSTEM 1 TIMER 1 CHANGE<
% OF CYCLE
CYCLE TIME