21
2.9. Water Meters / Totalizers
Each system with a timer on it will have 2 water meter inputs. Each of these can have the incoming contact
CONTACT VALUE
contact; i.e. 10.
CONTACT UNIT
for a contact; i.e. Gallons / Contact. If there is a mA
input set for a gpm or lpm reading, that mA input can
be selected in the Contact Units as the source for the
RESET TOTAL - Resets the totalizer count.
EVAP CALC
water meter inputs for an evaporation value.
DEBOUNCE - An additional amount of time the input
will wait before accepting another water meter contact
to reduce false contacts from a chattering read switch.
2.9.a. Option W Totalizers
Auxiliary Flow meter inputs have a Home menu selection for Totalizers. The Totalizer menu has selections
for each of the System Water Meters, plus one named Aux Meters.
Select the system water meter to set up or go to Aux
3. mA Signals
mA OUT SETTINGS - Selecting source and range of
outputs.
mA IN SETTINGS - Setting control and alarms for
inputs
mA OUT CALIBRATION - Calibrating outputs.
mA IN CALIBRATION - Calibrating inputs and
displayed range.
To Next Page
Loading...
