25
SENSOR 1
to be used in the calculation.
SENSOR 2 - The second sensor reading or Notepad
value to be used in the calculation.
4.2 mA Inputs
NAME - Name the input.
UNITS - Set the units of measurement.
NUMBER - Set the number range.
4.3 Run Screen
This lets you customize various aspects of the RUN
screen.
MAIN SCREEN - Customize what is displayed on the
RUN screen.
SCREENS SHOWN - Pick if the mA input & Aux Flow
screens are scrolled.
CYCLE TIME - The amount of time between screen
scrolls.
COND UNITS - Select the units of measure to be
displayed with the conductivity reading.
Provides access to menus to set-up passwords, relay
inputs, history time stamps, factory set-up and system
information.
FLOW SW
FACTORY - A factory only menu
TEMP SCALE - Set Celsius or Fahrenheit
ZIGBEE -
HISTORY - Sets the history time stamp interval.
SYS INFO
To Next Page
Loading...
