Advantage Engineering TRANS PRO X Series - Table of Contents

Advantage Engineering® TRANS PRO X-Series™ Table of Contents
Operations Manual Manual Printed in the U.S.A. for AEC GROUP INC. 1
TABLE OF CONTENTS
I. INTRODUCTION to the TRANS PRO X-SERIES ....................2
II. SAFETY INFORMATION ............................................................3
- Section 1.01: Important Safety Notice .........................................3
- Section 1.02: Important Safety Instructions.................................5
III. SYSTEM FEATURES & SPECIFICATIONS ...............................9
- Section 2.01: Features..................................................................9
- Section 2.02: Dimensions & Technical Specifications................10
- Section 2.03: Machine Overview................................................11
- Section 2.04: Control Panel Overview........................................12
IV. OPERATING PROCEDURES ...................................................14
- Section 3.01: Tool Usage / Battery Voltage Chart......................14
- Section 3.02: Overview of TRANS PRO Service Modes
of Transmission Fluid Exchange ..........................15
- Section 3.03: Dipstick Mode ......................................................16
- Section 3.04: Cooler Only Mode (TRANS PRO+ feature) ..........18
- Section 3.05: Manual/Top Off Mode ..........................................20
- Section 3.06: Drain Waste Tank Mode .......................................22
- Section 3.07: Total Count ...........................................................23
V. TROUBLESHOOTING & ADDITIONAL HELP.........................24
- Section 4.01: Troubleshooting Guide .........................................24
APPENDIX A - ADAPTERS (TRANS PRO+ feature)............................26
- Section 5.01: Adapters...............................................................26
APPENDIX B - REPLACEMENT PARTS .......................................28
- Section 5.02: Replacement Parts...............................................28
APPENDIX C - MAINTENANCE.....................................................32
- Section 6.01: Maintenance Procedures .....................................32
WARRANTY INFORMATION ..........................................................33