Advantech ADAM-5051 - Relay Output Modules

vii ADAM-5000 Series User Manual
Chapter 5 Relay Output Modules.......................47
5.1 Relay Output Modules............................................................................. 48
5.1.1 ADAM-5060 Relay Output Module.............................................. 48
Figure 5.1 ADAM-5060 Module Frontal View ............................ 48
Figure 5.2 Relay Output............................................................. 48
Table 5.1: Technical Specifications of ADAM-5060 .................. 48
5.1.2 ADAM-5069 Relay Output Module.............................................. 49
Figure 5.3 ADAM-5069 Module Front View Wiring.................... 49
Chapter 6 Counter/Frequency Modules............51
6.1 Counter/Frequency Modules................................................................... 52
6.1.1 ADAM-5080 4-ch Counter/Frequency Module............................ 52
Figure 6.1 ADAM-5080 Module ................................................. 53
Figure 6.2 Isolated Input Level .................................................. 53
Figure 6.3 TTL Input Level......................................................... 53
Figure 6.4 Counter / Frequency Mode....................................... 54
Figure 6.5 Wiring for Up/Down Counting................................... 55
Figure 6.6 Wiring for Bi-direction Counting................................ 55
Figure 6.7 Wiring for Frequency Mode ...................................... 56
Figure 6.8 Setting Alarm Limit ................................................... 56
Figure 6.9 Sending Alarm Signal (Recommended Settings) ..... 57
Figure 6.10Sending Alarm Signal (Not Recommended)............. 57
Figure 6.11Digital Output Mapping............................................. 58
Figure 6.12Jumper Location for Isolation Mode ......................... 59
Figure 6.13Jumper Location for TTL Mode ................................ 59
Table 6.1: ADAM-5080 Technical Specifications ...................... 59
Figure 6.14 Counter / Frequency Mode...................................... 60
Figure 6.15Wiring for Up/Down Counting................................... 61
Figure 6.16Wiring for Bi-direction Counting................................ 61
Figure 6.17Wiring for Frequency Mode ...................................... 62
Figure 6.18Setting Alarm Limit ................................................... 62
Figure 6.19Sending Alarm Signal (Recommended Settings) .....63
Figure 6.20Sending Alarm Signal (Not Recommended)............. 63
Figure 6.21Digital Output Mapping............................................. 64
Figure 6.22Jumper Location on the ADAM-5081 Module........... 65
Figure 6.23TTL/Isolated Input Level Select................................ 65
Table 6.2: ADAM-5081 Technical Specifications ...................... 65
Chapter 7 Serial Modules ...................................67
7.1 Serial Modules ........................................................................................ 68
7.1.1 ADAM-5090 4-port RS-232 Communication Module.................. 68
Table 7.1: Baud Rate Settings................................................... 68
Figure 7.1 ADAM-5090 Module ................................................. 68
Figure 7.2 ADAM-5090 Application Wiring ................................ 69
Table 7.2: Pin Mapping.............................................................. 69
Table 7.3: ADAM-5090 Technical Specifications ...................... 69
Figure 7.3 Jumper Locations on the CPU Card......................... 70
Figure 7.4 Jumper Settings........................................................ 70
7.1.2 ADAM-5091 4-port RS232/422/485 Communication Module..... 73
Table 7.4: Baud Rate Settings................................................... 73
Figure 7.5 ADAM-5091 Module ................................................. 74
Figure 7.6 ADAM-5091 Application Wiring ................................ 74
Table 7.5: PIN Mapping............................................................. 75
Figure 7.7 ADAM-5091 Jumper and switch location.................. 76
Table 7.6: Jumper Setting ......................................................... 76