EMC/EMI Compliance Statement: CE Mark Declaration of Conformance
Manufacturer's Disclaimer Statement: The information in this document is subject to change without notice and does not represent
a commitment on the part of the vendor. No warranty or representation, either expressed or implied, is made with respect to the quality,
accuracy or fitness for any particular purpose of this document. The manufacturer reserves the right to make changes to the content of this
document and/or the products associated with it at any time without obligation to notify any person or organisation of such changes. In no
event will the manufacturer be liable for direct, indirect, special, incidental or consequential damages arising out of the use or inability to
use this product or documentation, even if advised of the possibility of such damages. This document contains materials protected by
copyright. All rights are reserved. No part of this manual may be reproduced or transmitted in any form, by any means or for any purpose
without expressed written consent of its authors. Product names appearing in this document are mentioned for identification purchases
only. All trademarks, product names or brand names appearing in this document are registered property of their respective owners.
Contents
1 Introduction 3
1.2 Technical Specification 3
1.3 Number Types 3
2 Operation 4
2.1 Registration 5
2.2 Command Message Format 5
2.3 Master Number Setup 5
2.4 Allowing Master Control for All Users 6
2.5 Adding a User Number 6
2.6 Removing a User Number 6
2.7 Viewing the Valid Number List 7
2.8 Finding a Number in the Memory 8
2.9 Clearing All Numbers and Settings 8
2.10 Result Acknowledgement Message 8
3 Relay Operation/Access Control 8
3.1 Enabling Any Number and Disabling Open-on-Call 8
3.2 Call Reject 9
3.3 Connecting a Call 9
3.4 Input/Output Status Message 9
3.5 Relay Activation Mode 10
3.6 Relay Activation Time 10
3.7 OPEN/ON & CLOSE/OFF Commands 10
3.8 Exit Switch Enable 11
3.9 Output Change Acknowledge SMS 11
4 Auto-Dialler/SMS Sender 11
4.1 Input Triggered SMS Text Sending and Auto-Dialling 12
4.2 Input Change State Level 12
4.3 Customising the Input Alert Message 13
4.4 Autodial Logic 13
4.5 Changing the Maximum Ring Time 14
4.6 Changing the Maximum Call Time 14
4.7 Changing the Maximum Silence Time 14
4.8 Adding SMS Sender Text Numbers 14
4.9 Adding Auto-Dialler Call Numbers 14
4.10 Assigning a Number to One Channel Only 14
4.11 International Calling/Texting 15
4.12 Dial Now 15
4.13 Input Hold-off Timer 16
4.14 Silencing the Alarm 16
5 Setup 15
5.1 SIM Keep Alive Text 15
5.2 Signal Strength Indicator 15
5.3 Power Up/Reset Text Message 16
5.4 SIM Card Balance Checking and Service Data Forwarding 16
5.5 Forwarding SMS Messages to any Number 16
6 Installation 14
6.1 Power Connection 14
6.2 Input Connection 14
6.3 Connection to a Burglar Alarm 14
6.4 Output Connection 15
6.5 Antenna Connection 15
6.5 Mounting 15
7 Command Set Summary 16
To Next Page
Loading...
Need help?
General