User Numbers
User numbers are only able to operate the relay output. This can be via SMS text or by call-
ing the board. Unless MUSER is enabled (this makes all numbers master numbers) user num-
bers cannot access any command functions.
Example User Number setup command:
Add 07000000000.
Text Numbers
These numbers are the recipients of input triggered SMS text messages. The board sends
SMS text messages to these numbers in the order in which they are added. These numbers
cannot access any of the board’s command functions but are able to operate the output
relay by call or text. Note, if a master or user sends a command to the board which results
in a SMS text reply, the reply is sent to the sender of the command and not the list of text
numbers.
Example Text Number setup command:
TEXTNUM 07000000000.
Call Numbers
Call numbers are dialled when the input is triggered. Call numbers are dialled before the
sending of SMS text messages to the Text Numbers. They are dialled in the order in which
they are added. The numbers are dialled sequentially until a call is answered and rejected
or a call is answered and the # key is pressed. See Section 4.1 Auto-Dialler for details.
Example Call Number setup command:
Callnum 07000000000.
Data Numbers
Data Numbers are setup in a similar way to master numbers and allow settings to be
amended using software. A call from a data number may leave the unit unresponsive for
up to 3 minutes after the call has ended. Data numbers cannot activate the output relay.
Details of the software are not covered in this manual. Please see the Advent Controls web-
site/blog.
Data 07000000000,37212. for module with IMEI 355073034237212
2. Operation
2.1 Registration
A valid GSM Subscriber Identity Module (SIM) card must be present in the SIM holder for the
system to operate. Immediately on power up the system will attempt to register on the SIM
card on it’s home network. Once registration has occurred LED1 will change from flashing
approximately once every second to a momentary flash once every two seconds. If the
LED1 continues to flash once every second for some time, the system cannot register the
SIM on the network. The system will restart should this occur. If the problem persists check
the antenna and strength of signal in your area/validation of the SIM card. Remove any PIN
numbers from the SIM card. Observe anti-static precautions when inserting the SIM.
To Next Page
Loading...
Need help?
General