Network Bullet Camera·Quick Start Guide
3). Adjust the tilt direction [0° to 90°].
4). Rotate the camera [0° to 360°] to adjust the lens to the
surveillance angle.
5). Tighten the adjusting nut to complete the installation.
Installation of Network Cable Water-proof
Jacket
Purpose:
If the camera is installed outdoor, you can adapt the water-proof
accessory for the network cable after the camera is secured on the
installation surface.
Figure 2-6 Water-proof Accessory Components
Table 2-1 Components
Camera’s Network Interface Socket
To Next Page
Loading...
