Installation and connection instructions
41
Levelling the appliance
3
Self adjusting foot: The rear foot of your washing machine is designed
like a spring leg. This makes the machine very stable even at high spin
speeds.
If the washing machine is still not stable during spinning, proceed as
follows:
0 1. Set the three adjustable feet to
the nominal value of 10 mm.
Use the supplied spanner.
If the self adjusting foot does
not reach the floor:
2. Manually extend the self
adjusting foot (rear left) to
the required length.
3. Check the appliance is level using
a spirit level.
Important! Never use strips or
shims of wood or cardboard etc.
to compensate for any uneven-
ness in the floor. Always use
the adjustable feet.
To Next Page
Loading...
