Problem Possible cause Remedy
The water in the cavity em-
bossment does not boil.
The temperature is too low. Set the temperature at least
to 110 °C.
Refer to "Hints and tips"
chapter.
The water comes out of the
cavity embossment.
There is too much water in
the cavity embossment.
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to the specific procedure.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the oven cavity. Do
not remove the rating plate from the
oven cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
13. ENERGY EFFICIENCY
13.1 Product Fiche and information according to EU 65-66/2014
Supplier's name AEG
Model identification
BEE455120M
BEK455120M
Energy Efficiency Index 81.2
Energy efficiency class A+
Energy consumption with a standard load, conven-
tional mode
0.99 kWh/cycle
Energy consumption with a standard load, fan-forced
mode
0.69 kWh/cycle
Number of cavities 1
Heat source Electricity
www.aeg.com30
To Next Page
Loading...
