AEG BFP6202M - Troubleshooting

CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem Check if...
You cannot activate or operate the appliance. The appliance is correctly connected to an electrical
supply.
The appliance does not heat up. The automatic switch-off is deactivated.
The appliance does not heat up. The appliance door is closed.
The appliance does not heat up. The fuse is not blown.
The appliance does not heat up. Lock is deactivated.
The lamp is turned off. Moist Fan Baking - is activated.
The lamp does not work. The lamp is burnt out.
The Food sensor does not operate. The plug of the Food sensor is fully inserted into the
socket.
Err C2 You removed the Food sensor plug from the socket.
Err C3 The appliance door is closed or the door lock is not bro‐
ken.
Err F102 The appliance door is closed.
Err F102 The door lock is not broken.
The display shows 00:00. There was a power cut. Set the time of day.
The water leaks out of the cavity embossment. There is too much water in the cavity embossment.
If the display shows an error code that is
not in this table, turn the house fuse off
and on to restart the appliance. If the
error code recurs contact an Authorised
Service Centre.
13.2 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on the
24 ENGLISH