AEG BSS 4808 - Device Operation and Battery Handling; Remote Control Battery Replacement; Basic Operation and Controls

English
48
WARNING:
Donotexposetointenseheat,e.g.sunlight,reetc.Dan-
ger of explosion!
Insert/Replace Battery in Remote Control
NOTE:
The lithium cell in the battery compartment of the remote
control may have been safeguarded for transport with a
pieceoffoil.Thisextendsthelifeofthebattery.Please
remove this foil before the first use to make the remote
control ready for operation.
• Openthebatterycompartmentontheundersideofthe
remote.
• Replacethecellbyabatteryofthesametype(CR2032).
Check that the polarity is correct (see battery compart-
ment).
• Closethebatterycompartment.
If the remote is not in use for a lengthy period of time, please
remove the battery to prevent the battery acid from “leaking”.
WARNING:
• Thebatteryshallnotbeexposedtoexcessiveheat
such as sunshine, fire or the like. Danger of explosion!
• Keepbatteriesoutofthereachofchildren.Theyare
not toys.
• Donotforcebatteriesopen.
• Avoidcontactwithmetallicobjects.Rings,nails,screws
etc.) Danger of short circuits!
• Shortcircuitsmayoverheatorevenignitebatteries.
This may lead to combustion.
• Whentransportingthebatteries,covertheterminalsfor
your safety with an adhesive strip.
• Ifabatteryleaks,donotrubtheuidintotheeyesor
the skin. If acid comes into contact with the eyes, rinse
with purified water and seek medical advice if symp-
toms persist.
CAUTION:
Batteries must not be disposed of in the garbage. Please
bring used batteries to competent collection centers or
back to the dealer.
Transport securing device of CD compartment
• PulltheCDcompartment(1)upwardsonthehandle(2)in
order to open it.
• Remove,ifpresent,thetransportsecuringdevicefrom
the CD player before starting operation.
• ClosetheCDcompartmentagain.
Turning the device on/ off
• TurnthedeviceonbysettingthePOWERON/OFF
switch to the “ON” position on the rear side of the
device.
• Toturnoffthedevice,setthePOWERON/OFFswitch
to the “OFF” position. Then, disconnect the device from
the mains.
Setting the clock (during standby mode)
1. Briefly hold down the PROG button (10/4). The display
will show “24 HOUR”.
2. Use the
/ button (9/8) to select between 24-hour and
12-hour display setting. Confirm with PROG.
NOTE: The 12-hour setting will result in the following
display
AM = morning, PM = afternoon.
3. Use
/ buttons to set the hours. Confirm with PROG.
4. Use / buttons to set the minutes.
5. Press PROG again in order to save the time settings.
General operation
NOTE:
Some buttons you will find on both the device and the
remote control. Buttons with the same name result in
the same functions.
STANDBY/ON (17/1)
Press STANDBY button to switch the device into standby
mode. Press this button again to turn on the device.
NOTE: In the BLUETOOTH, USB, CARD, AUX and CD
mode
Afterapprox.20minuteswithoutasignal,thedeviceauto-
matically switches to standby.
Volume (3/10)
Adjust to your preferred volume level. The display will show
“VOL” and a number. This will equal to the set volume of
“VOL MAX” or “VOL MIN”.
BASS control (20)
You can use this control to adjust the bass individually. The
display will show “BASS” and a number.
Infrared remote control
Wireless operation from a distance of up to 5 meters. If this
range gets less, please change the battery . Make sure there
are no obstacles between the remote control and the sensor
(5) on the device during operation.
AUX IN jack (12)
Connect analogue playback devices. When connecting to
this jack you may also listen to the audio of other devices,
such as MP3 or CD players etc., via the speakers.
1. Flip the cover downwards.
2. Pleaseconnecttheexternaldevicevia3.5mmplugjack
to the AUX IN jack.