Fluid Dynamic Efficiency class A
Lighting Efficiency - LEhood - lux/W
Lighting Efficiency Class -
Grease Filtering Efficiency - GFEhood 85.1 %
Grease Filtering Efficiency class B
Minimum Air Flow in normal use 260.0 m3/h
Maximum Air Flow in normal use 500.0 m3/h
Air Flow at intensive/boost setting 630.0 m3/h
A-weighted Sound Power Emissions at minimum speed 48 db(A) re 1 pW
A-weighted Sound Power Emissions at maximum speed 64 db(A) re 1 pW
A-weighted Sound Power Emissions at intensive or boost speed 69 db(A) re 1 pW
Measured power consumption off mode - Po 0.49 W
Measured power consumption in standby mode - Ps - W
Additional Information
Time increase factor - f 0.8
Energy Efficiency Index - EEIhood 42.0
Measured air flow rate at best efficiency point - QBEP 268.5 m3/h
Measured air pressure at best efficiency point - PBEP 469 Pa
Maximum air flow - Qmax 630.0 m3/h
Measured electric power input at best efficiency point - WBEP 105.8 W
Nominal power of the lighting system - WL - W
Average illumination of the lighting system on the cooking surface - Emiddle - lux
Appliance tested according to: IEC / EN
61591, BS EN 61591, IEC / EN 60704-1, BS
EN 60704-1, IEC / EN 60704-2-13, BS EN
60704-2-13, IEC / EN 50564, BS EN 50564.
The data in the table above refers to the
appliances in exhaust mode. The appliances
in recirculation mode can be transformed into
exhaust mode by following the installation
instructions provided in the installation
booklet, and by using a dedicated filter
available in our official stores. For more
information visit our website.
12.4 Hood - Energy saving
You can save energy during everyday
cooking if you follow the hints below.
• When you start cooking, set the hood fan
at a low speed level. Once the cooking is
finished, keep the hood running for a few
minutes.
• Increase the fan speed only to get rid of
large amounts of steam or smoke. It is
recommended to use the Boost function
only in extreme situations.
• Clean the hood filter regularly and replace
it when necessary to maintain its
efficiency.
• Use the maximum diameter of the ducting
system to optimize efficiency and minimize
noise.
26 ENGLISH
To Next Page
Loading...
