AEG CCX6740ACW - Service Data; Energy Efficiency

Problem Possible cause Remedy
There is no good cooking perform‐
ance using the SteamBake function.
You did not fill the cavity emboss‐
ment with water.
Refer to "Activating the SteamBake
function".
The water in the cavity embossment
does not boil.
The temperature is too low. Set the temperature at least to
110°C. Refer to "Oven - Hints and
tips" chapter.
The water comes out of the cavity
embossment.
There is to much water in the cavity
embossment.
Deactivate the oven and make sure
that the appliance is cold. Wipe the
water with a cloth or sponge. Add
the correct amount of water to the
cavity embossment. Refer to "Acti‐
vating the SteamBake function".
13.2 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on the
front frame of the appliance cavity. Do not
remove the rating plate from the appliance
cavity.
We recommend that you write the data
here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
14. ENERGY EFFICIENCY
14.1 Product Information according to EU and UK Ecodesign Regulations
for Hob
Model identification CCX6740ACW
CCX6740ACB
CCX6740ACM
Type of hob Hob inside Freestanding Cooker
Number of cooking zones 4
Heating technology Radiant Heater
Diameter of circular cooking zones
(Ø)
Left front
Left rear
Right front
Right rear
21.0 cm
14.5 cm
14.5 cm
18.0 cm
Energy consumption per cooking
zone (EC electric cooking)
Left front
Left rear
Right front
Right rear
188.1 Wh/kg
181.8 Wh/kg
181.8 Wh/kg
192.3 Wh/kg
Energy consumption of the hob (EC electric hob) 186.0 Wh/kg
IEC/EN 60350-2 - Household electric cooking appliances - Part 2: Hobs - Methods for measuring performance.
ENGLISH 25