• Turn off the appliance and wait until it is
cold.
• Remove all accessories and removable
shelf supports.
• Clean only the oven floor and the inner
door glass with warm water, soft cloth and
mild detergent.
Cleaning the main oven with catalytic
cleaning
1. Select Menu / Cleaning
2. Press .
The duration of the cleaning is fixed (1 h).
When the cleaning ends the signal sounds.
The oven turns off.
3. When the oven is cold, clean the oven
floor with a wet soft cloth.
Cleaning the top oven with catalytic
cleaning
1. Set the function: .
2. Set the maximum oven temperature.
The duration of the cleaning is fixed (1 h).
3. After cleaning, turn the knob for the
heating functions to the off position.
4. When the oven is cold, clean the oven
floor with a wet soft cloth
11.4 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Fully open the door.
2. Press the clamping levers on the two
door hinges.
3.
Close the oven door to the first opening
position (at approximate angle: 70°).
4. Hold the door with one hand on each side
and pull it away from the oven at an
upwards angle.
5. Put the door with the outer side down on
a soft cloth on a stable surface.
6. Hold the door trim on the top edge of
the door at the two sides and push
inwards to release the clip seal.
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.
Make sure that the glass panels are inserted
in the correct position otherwise the surface
of the door may overheat.
ENGLISH 15
To Next Page
Loading...
