AEG DCE731110M - Setting the End; Setting the Time Delay Function; Setting the SET+GO; Setting: Minute Minder

7.4 Setting the END
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press or to set the END and
press
. First you set the minutes
and then the hours.
When the set time ends, the signal
sounds for 2 minutes. The display shows
flashing and the time setting . The
oven turns off automatically.
4. Press a sensor field to stop the
signal.
5. Turn off the oven.
7.5 Setting the TIME DELAY
function
1. Set a heating function and
temperature.
2. Press
again and again until
starts to flash.
3. Press or to set the minutes for
DURATION.
4. Press .
5. Press
or to set the hours for
DURATION.
6. Press .
The display shows flashing
.
7. Press or to set the END time
and press
. First you set the
minutes and then the hours.
The oven turns on automatically later on,
works for the set DURATION time and
stops at the set END time. When the set
time ends, the signal sounds for 2
minutes. The display shows flashing
and the time setting . The oven turns off
automatically.
8. Press a sensor field to stop the
signal.
9. Turn off the oven.
When the Time delay
function is turned on, the
display shows a symbol of
the heating function, with
a dot and . The dot shows
which clock function is on in
the Clock / residual heat
display.
7.6 Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set a heating function and
temperature.
2. Set the DURATION.
3. Press again and again until the
display shows flashing .
4. Press to set the SET+GO
function.
The display shows
and with an
indicator. This indicator shows which
clock function is activated.
5. Press a sensor field (apart from ON /
OFF) to start the SET+GO function.
7.7 Setting: Minute Minder
1. Press .
The display shows flashing and "00".
2. Press to switch between options.
First you set the seconds, then the
minutes and the hours.
3. Press or to set the MINUTE
MINDER and to confirm.
4. Press or the MINUTE MINDER
starts automatically after 5 seconds.
When the set time ends, the signal
sounds for 2 minutes and the display
shows flashing 00:00 and .
5. Press a sensor field to stop the
signal.
7.8 COUNT UP TIMER
1. To reset the Count Up Timer press:
and at the same time .
2. When the display shows "00:00" the
Count Up Timer starts to count up
again.
ENGLISH
13