EasyManua.ls Logo

AEG DDLE LCD 27 User Manual

AEG DDLE LCD 27
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
DDLE LCD 18
DDLE LCD 18/21/24
DDLE LCD 27
Elektronisch geregelter Durchlauferhitzer
Gebrauchs- und Montageanweisung
Electronically controlled instantaneous water heater
Operating and installation instructions
Elektronicky regulovaný průtokový ohřívač
Návod k používání a montáži
Elektronicznie regulowany przepływowy
ogrzewacz wody
Instrukcja obsługi i montażu
Проточный водонагреватель с электронной
регулировкой
Обслуживание и установка
Question and Answer IconNeed help?

Do you have a question about the AEG DDLE LCD 27 and is the answer not in the manual?

AEG DDLE LCD 27 Specifications

General IconGeneral
Display typeLCD
Electronic power controlYes
TypeTankless (instantaneous)
Fuel typeElectric
Product colorWhite
Heater locationIndoor
Placement supportedVertical
Solar batteries support-
International Protection (IP) codeIP25
AC input voltage400 V
Annual energy consumption481 kWh
Efficiency39 %
Noise level15 dB
Maximum power27000 W
Thermostat range30 - 60 °C
Domestic Hot Water (DHW) flow- l/min
Weight and Dimensions IconWeight and Dimensions
Depth93 mm
Width226 mm
Height485 mm
Weight4000 g

Summary

Operating Instructions

Equipment Description

Describes the instantaneous water heater's function and temperature control.

Vital Facts

Key operational facts, temperature selector, and energy-saving recommendations.

Safety Information

Warning about scalding risk and supervision of users with limited capabilities.

Important Operational Information

Steps to take before restarting the heater after water supply interruption.

Installation Instructions

Equipment Layout

Diagram and list of components of the water heater.

Important Air Supply Information

Critical information regarding air in the water supply and its impact on the heating system.

Instructions and Regulations

Requirements for installation, commissioning, and maintenance by qualified contractors.

Standard Installation

Water Connection

Procedures for connecting the water supply, including flushing and flow limiter checks.

Power Supply (Standard Installation)

Details on connecting the power cable, earth connection, and cable grommet.

Commissioning

Procedures for commissioning the device, including filling, venting, and testing.

Alternative Installation Methods

Temperature Limit

How to set a permanent maximum outlet temperature limit of 43 °C.

Specification and Application Areas

Troubleshooting by User

Troubleshooting by Contractor

Related product manuals