16 Rev 0.0
USER INSTRUCTIONS
EN
N.B.: the display indicates the water hardness adjustment and the pro-
gram delay. A dot (.) after the number means that the water hardness
adjustment is being displayed. If no dot (.) appears, the program delay
is being displayed.
Water hardness table (see tab. 2-03)
WATER HARDNESS
SETTING
German degrees (°D) French degrees (°F)
American degrees
grains/galls
0 - 4 0 - 7 0 - 4.5 0.
5 - 15 8 - 25 4.6 - 14.5 1.
16 - 23 26 - 40 14.6 - 23.5 2.
24 - 31 41 - 60 23.6 - 35 3.
32 - 47 61 - 80 35.1 - 46.5 4.
48 - 58 81 - 100 46.6 - 58.5 5.
Tab. 2-03
Contact your local water board for information on the hardness of your water
supply.
If it is necessary to open the door during the washing cycle, the program
will be interrupted, the relative indicator light will continue to ash and
a beep will indicate that the cycle has not terminated. Wait for about 1
minute before closing the door and continuing with the program. When
the door closes, the program will start from where it was interrupted. This
operation should be performed only if necessary as it could cause irregu-
lar program performance.
FIG. 205
To Next Page
