20 Rev 0.0
USER INSTRUCTIONS
EN
FAULT DESCRIPTION
E6
Water pump-out malfunction
The appliance does not pump out the water or does so
incorrectly. Make sure the drain hose is not kinked or
crushed and that the siphon and lters are not clogged.
If the problem persists, contact the technical assistance
service.
E7
Turbine ow-regulator malfunction
(only for models tted with this feature)
The appliance is unable to precisely measure the quantity
of incoming water. Interrupt the current program and
switch o the dishwasher. Switch it back on again,
program a new cycle and press start. If the problem
persists, contact the technical assistance service.
E8
Alternate washing system malfunction
Interrupt the current program and switch o the
dishwasher. Switch it back on again, program a new
cycle and press start. If the problem persists, contact the
technical assistance service.
E9
Water intake system malfunction
Contact the technical assistance service.
Tab. 5-01b
Light o Light on Light ashing
If an alarm situation occurs, the dishwasher interrupts the current program and
signals the fault.
Alarms • E1, E2, E3, E4, E8, E9 immediately terminate the current program.
Alarms• E5, E6 interrupt the current program and, after the problem has been
eliminated, resume the cycle.
Alarm • E7 is displayed at the end of the cycle which, however, is completed
given that it does not jeopardize the operation of the dishwasher.
To “reset” an alarm:
open or close the door, or switch the appliance on and back o again. At this •
point, the dishwasher can be programmed again.
If the fault persists, contact the Authorized Technical Assistance Service.
To Next Page
Loading...
