AEG K 19 E - Using the Unit as a Dehumidifier; Collecting Condensation Internally; Discharging Condensation Externally; Using the Unit as a Heater

Whichever method is preferred, the window should
be opened as little as possible in order to ensure
maximum efficiency. If the window is fitted with
shutters of blinds, these should be partially closed
in order to reduce exposure to direct sunlight and
to prevent warm air from entering the room.
Do not obstruct the exhaust vent.
N.B.: Check that the air-conditioner is perfect-
ly level. If necessary, fit the special ©
stops to the two front castors.
USING THE UNIT AS A
DEHUMIDIFIER
e Position the unit anywhere in the room to be
dehumidified without fitting the exhaust hose,
so that the air is vented directly into the room.
Maintain the clearance distances indicated at
back, sides and front. The condensation water
can be collected in the internal canister or
piped to the exterior.
a) Collecting the condensation in
the internal tank -°
The condensation is collected in the internal
canister. When the canister is full, the FULL pilot
lamp lights andthe appliance switches off. In this
case, empty the canister and restartthe appliance.
SZ
b) Discharging the condensation
externally through the
condensation tube
. Remove the condensation tube from the rear
compartment, remove the plug and connect toa
_ floor-level drainage duct. The condensation tube
can be fitted with an extension tube (maximum
length 2 m.). The extension tube must be of the
same diameter and positioned at floor level. Take
care not to crush the extension tube. —
‘The condensation can also be drained into a
basin (maximum height 11cm.). Inthis case, care
should be taken to prevent overflowing.
When unit is used as an air-conditioner, the
humidity of the air in the room is’ reduced
automatically.
When the unit is used as a dehumidifier, it
also heats the room with a power of 690W.
USING THE UNIT AS:A HEATER
e Position the unit anywhere in the room to be
heated without fitting the discharge hose.
Maintain the clearance distances indicated a
back, sides and front.
21