AEG K 19 E - Electrical Connections

- ELECTRICAL CONNECTIONS
_ Before plugging the unit into the mains, check
— the following: on YRS oe
¢ the mains voltage must be the same as the
«ex voltage shown on the rating plate |
* the power socket and the mains circuit must be
_ Suitable for the power requirements of the unit
e the socket must be suitable for the plug; if not,
have the socket replaced
‘@ the power socket must be properly earthed.
The manufacturer declines all responsibility
for any damage or injury arising from non-
observance of this safety requirement.
This appliance is manufactured in
compliance with EEC Directive 87/308
regarding the suppression of radio
interference.
In order to ensure that your air-conditioner
operates with the maximum efficiency, make sure
that: |
* all doors and windows in the room to be air- —
conditioned are closed (except for temporary
_ installation, in which. case awindowmustbe left
_ partially open).
Draw the curtains
_@ Draw the curtains and/or partially close the
blindsto protectthe room against direct sunlight.
This will increase the efficiency and economy °
of the air-conditioner.
- ¢ Do not place objects. of any kind on the air-
conditioner.
* Maintain the clearance distances indicated at
back, sides and front. —
e Make sure that there are no unnecessary
sources of heat in the room. . | |
A
A)
ff.
BBE Vf
Vlllses
Do not cover
YOUR AIR-CONDITIONER IS NOW READY FOR:
USE,