19 GB
WARNING!
Read all safety guidelines and
instructions. Omissions regarding the compliance
to safety guidelines and instructions can cause
electrical shock, fire and / or serious injuries.
Keep all safety guidelines and instructions for
future reference.
DANGER OF ACCIDENT AND LIFE
FOR INFANTS AND CHILDREN!
Never leave children unsupervised
with the packing material. There is danger of
suffocation.
This device is not intended for use by persons
(including children) with reduced physical,
sensory or mental abilities or lack of experi-
ence and / or lack of knowledge unless they
are supervised by a person responsible for
their security or received instructions from
this person, how the equipment is to be used.
Children should be supervised, in order to
guarantee that they do not play with the
device.
Keep the device away from children. Children
are not able to understand and recognise the
possible risks during the handling of electrical
devices.
Keep the device away from rain and dampness.
Water penetrated into electrical appliances
means mortal danger by electrical shock.
Pay attentions that all plugs and power
cables are free of dampness. Never switch
on the device with damp or wet hands.
Only use the device when power cable and
housing a free of damage.
Pay attention that the power cables are
secured.
Do not use a power cable to carry the device
or pull it. Damaged power cable means mortal
danger by electrical shock.
Always pull the plug; never pull the power
cable to separate the device from the voltage
source.
If cables a routed through walls with sharp
edges, for example metal walls, use empty
pipes or piping to avoid damaging the cable.
Never route the main cables with 230 V
together with direct current cables of 12 V DC
in the same pipe Rohr (one piping).
Route the power cable in such a way that no
one trips and no one can damage the cables.
Do not route the cables next to conductive
materials. Do not fold the cables and protect
them against damages.
Damaged cables must be exchanged imme-
diately.
Avoid short circuits and bridges with foreign
objects between in- and outputs of the voltage
inverter. Use only bonding pins or fork wall
pins to connect devices to the output sockets.
Even if the build in fuse is released, some
parts remain under load.
Pay attention that the device is always used
in a safe place.
Choose the set-up place for the device with
care.
The maintenance work must be accomplished
by a qualified electrician.
Do not operate the device if it is damaged.
Do not expose the device to
- extreme temperatures,
- strong vibrations,
- strong mechanical load
- direct sunlight,
- dampness.
Otherwise damage to the device is likely.
Note that damages caused by improper
handling, ignorance to the operating manual
or interference by unauthorised persons are
excluded from the warranty.
Never dismantle the device. Inappropriate
repairs can cause considerable dangers for
the user.
Only let specialists do repairs.
Before start-up
Before you start up the voltage inverter, the
connections on the battery of the vehicle must
be checked.
If the plus-pole (+) of the vehicle battery is
connected to the chassis, you are not allowed to
use the voltage converter with such vehicles.
Introduction / Security
To Next Page
Loading...
