AEG TP7060TW - Daily Use

9. DAILY USE
9.1 Start a programme without delay
start
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when you close the
door, the laundry does not get caught
between the appliance door and the
rubber seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options
for the type of load.
The display shows the programme duration.
Real drying time will depend on type of
the load (quantity and composition), the
room temperature and the humidity of
your laundry after spin drying phase.
4. Press the Start/Pause touch button.
The programme starts.
9.2 Starting the programme with
delay start
1. Set the correct programme and options
for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
You can delay the start of a
programme from a minimum of 1
hour to a maximum of 20 hours.
3. Press the Start/Pause touch button.
The display shows the countdown of the
delay start.
When the countdown is completed, the
programme starts.
9.3 Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
Alternatively:
1. Rotate the selector knob to the "Reset"
position.
2. Wait for 1 second. The display shows
.
3. Set the programme.
9.4 At the end of the programme
When the programme is completed:
• An intermittent acoustic signal operates.
• The display shows
• The indicators Sieb (Filter) and
Behälter (Tank) comes on.
• The Start/Pause indicator is on.
The appliance continues to operate with the
anti-crease phase for approximately 30
minutes or more if Knitterschutz (Extra
Anticrease) option was set (see chapter
Option - Knitterschutz (Extra Anticrease) ).
The anti-crease phase reduces creasing.
You can remove the laundry before the anti-
crease phase is completed. We recommend,
for better results, that you remove the laundry
when the phase is almost completed or
completed.
When the anti-crease phase is completed:
• The display still shows
• The indicators Sieb (Filter) and
Behälter (Tank) comes on.
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
ENGLISH 15