17
9.
Transportation and storage
9-1 When the product is transported, the circuit breaker shall be placed in a closed packing box
without energy storage, and a proper amount of desiccant shall be built in. The circuit breaker shall be
protected with plastic film to prevent water penetration during loading and unloading and dust intrusion
during storage.
9-2 The following tools shall be used to load and unload the packing box
●
Crane
●
Forklift
●
Driving
9-3 Pay attention to the following items during transportation:
●
Avoid shocks
●
Avoid other destructive mechanical forces
●
The lifting appliance should not be hooked on the circuit breaker body or operating mechanism. It
should be hooked at the lifting position with lifting mark.
9-4 The circuit breaker shall be stored in the state of opening of operating mechanism and energy
storage spring without energy storage.
Basic storage requirements
●
The dry and well ventilated storage room shall meet the relevant provisions of GB /T 1984 and
IEC 60694.
●
The temperature of the storage room shall not be lower than - 15 ° C.
●
Do not disassemble or damage the package. Cover with a protective light covering and maintain
adequate ventilation.
●
Regularly check whether there is condensation phenomenon and other conditions not suitable for
storage requirements.
10.
Random documents
a. Product certificate
b. Factory inspection report
c. Packing list
11.
Spare parts
When the user needs, the spare parts can be determined according to the following list, and put
forward when ordering, so as to meet the needs.
To Next Page
Loading...
