MARINATING IN THE POUCH
Use the ON/OFF switch -1- located
to the left of the control panel to
switch the appliance on.
Place the food with the marinade
inside the pouch. Place the pouch
inside the tank.
Select one of the programs between
P1 and P5 with vacuum at 99.9%
and sealing time set at 2 seconds,
using keys keys -9- and -10-.
Close the cover and press Start -8- .
Open the cover, as soon as the
display shows the program (e.g. P1).
Store in the refrigerator for 9-12
hours.
9. ADDITIONAL FUNCTIONS
9.1. P6 “External vacuum”
This program must be used to
eliminate the air inside special air-tight
containers (not supplied with this
product).
Unscrew the intake fitting placed
inside the tank
Tighten the "external vacuum" fitting
Connect this fitting to the container
using the intake pipe.
With the open cover, start the
program by pressing Start
This program allows only the "vacuum"
program to be set.
9.2. P7 “Conditioning Program”
This program must be used in the
following situations:
Before using the machine for the first
time.
After a long stop period.
After having sealed products with
high humidity content (e.g. soups).
When you notice a decrease in
performance of the machine (e.g.:
time to reach vacuum is increased
or it does not reach it at all).
This program lasts about 3 minutes
and ensures a complete cleaning of
the pump, removing any liquid
emulsion that might be found in the oil.
Do not seal any product while this
program is running.
This program has no set variables.
Follow the indications below to start
the program:Close the cover with the
empty tank
Select program P7 using keys keys
-9- and -10- .
Press Start -8- .
Wait for the cycle to end (about 3
minutes).
At the end of the cycle, the display
shows P7 again.
Now the machine is ready for use
To Next Page
Loading...
