AEG VS92903M - Initial Setup and First Use Procedures; Pre-Operation Oil Check; Initial Cleaning Before First Use; Connection and Conditioning Program

7
ENGLISH
4. BEFORE USING FOR THE FIRST TIME
WARNING!
Ensure oil has been added before
operating the appliance. Refer to
Installation section for how to do this.
WARNING!
Refer to the chapters on safety.
4.1. Cleaning for the first time
 Remove all the parts from the
appliance.
 Clean the appliance before you use
it for the first time.
Refer to the "Cleaning and
maintenance" chapter.
4.2. First connection
 Connect the appliance to the power
supply.
 Use the ON/OFF switch -1- locate to
the left of the control panel to
switch the appliance on.
 Before using the appliance, proceed
with the “Conditioning Program”
as shown below:
 Close the cover with the empty tank.
 Select program P7 using the keys
-9- and -10-.

 Press Start -8- .
 Wait for the cycle to end (about 3
minutes).
 At the end of the cycle, the display
shows P7 again.
 Now the machine is ready for use.
5. CONTROL PANEL
ON/OFF switch
Selection button
ON/OFF LED
Start button
Vacuum function LED
“DECREASE” button, reduces the set function
values and selects the programs
Sealing function LED
“INCREASE” button, increases the set
Function values and selects the programs
Air return function LED
Display. Displays the selected functions and
the relative setting data.
Stop button