However, the device may also emit an unpleasant odor when the filter is
clogged. In this case, the filter must be cleaned or replaced. If you smell
burning, unplug the purifier immediately. Then, contact our Support Dept or
the Seller of the device for assistance.
5. The filter change LED is blinking after the filter was replaced or cleaned.
Possible causes and solutions: Press and hold the UV/FILTER button for at
least 7 seconds. The filter replacement timer will restart, and the indicator
will turn off.
ATTENTION! If your problem persists, please contact your local supplier or the
service center for support. Please do not disassemble the device or try to repair
it on your own.
Connection to the AENO mobile app
ATTENTION! Please make sure that your phone is connected to a 2.4 GHz
Wi-Fi network as 5 GHz networks are not supported by the device.
Connect the device to a power supply and turn it on.
Download the AENO mobile app from Google Play or the App Store and
create a new account or log in to your user account.
On the main screen of the app, tap "+" or "Add device" (if there are no added
devices in the app). Select "Air purifier" in the window that opens.
Note: If the system prompts you to turn on any features on your smartphone,
follow the recommendations in the prompts.
Enter your Wi-Fi network name and password if the fields have not been
filled in automatically. Tap "Next". Make sure that the EZ mode is selected in
the upper right corner.
If the Wi-Fi icon on the device control panel is blinking, go to the next step
of the instructions. If the Wi-Fi icon is not blinking, press and hold the
"TIMER" button for about 7 seconds until it starts blinking.
On the "Tips to Connect Devices" screen, check the "Make sure that the LED
indicator is blinking" box and tap "Next".
To Next Page
Loading...