Please read this and other device guides carefully. Failure to follow the recommendations set forth by Aeotec Limited
may be dangerous or cause a violation of the law. The manufacturer, importer, distributor, and / or reseller will not be
held responsible for any loss or damage resulting from not following any instructions in this guide or in other materials.
WallMote Quad is intended for indoor use in dry locations only. Do not use in damp, moist, and / or wet locations.
Keep product and batteries away from open flames and extreme heat. Avoid direct sun light or heat exposure. Always
remove all batteries from products that are being stored and not used. Batteries may damage the appliance if they
leak. Ensure correct polarity when inserting the batteries. Improper battery use may damage the product.
Do not apply permanent power. Do not charge for more than 3 hours at a time.
Quick start.
Power up your NanoMote Quad.
Initially NanoMote will be unpowered with its battery blocked by a plastic cover, this plastic cover must be released to
initially power up your NanoMote.
1. Open up NanoMote cover by twisting the back cover counter-clockwise to unlock.
2. Remove the battery and plastic cover
3. Place battery back into battery holder
Nano Mote Quad User Guide : Aeotec Group
https://aeotec.freshdesk.com/support/solutions/articles/6000184696-n...
To Next Page
Loading...
Need help?
General
