Aeotec NanoMote Quad User Guide

release its button to put your NanoMote to sleep.
With your NanoMote Quad now working as a part of your smart home, you’ll be able to configure it from your home
control software or phone application. Please refer to your software’s user guide for precise instructions on configuring
the NanoMote Quad to your needs.
Advanced Functions.
Send a wake up notification.
In order to send your NanoMote Quad new configuration commands, OTA, or receive other commands from your
Z-Wave controller or gateway, it will need to be woken up.
Enable Wakeup:
1. Press and hold button (any button) for 5 seconds or until LED turns to a green color
LED will change from:
Orange
Green //at 5 seconds.
2. Release the button and the LED will flash green rapidly to indicate it is in an awake state.
Disable Wakeup:
1. Press and hold button (any button) for 2 seconds or until LED turns to a orange/red color
2. Release the button and the LED should be deactivated
Child Lock NanoMote.
You can use the Child Lock function to disable NanoMote control over your devices and scene triggers.
You can toggle child lock on/off by:
1. Press and hold NanoMote button (can be any button)
LED will change from:
Orange
Green
Red //at 10 seconds of holding
2. When LED turns red (after 10 seconds), release its button.
3. Tap button again while second Red LED is illuminated (you'll have 2 seconds to do so), if successful, the red
LED will flash for 1-2 seconds.
Nano Mote Quad User Guide : Aeotec Group
https://aeotec.freshdesk.com/support/solutions/articles/6000184696-n...
4 z 9
9. 9. 2019, 15:53

Aeotec NanoMote Quad Specifications

General

Brand	Aeotec
Model	NanoMote Quad
Category	Switch
Language	English