Association table of the control buttons.
The NanoMote Quad supports 9 association groups, all control buttons can activate the configured scenes via sending
the Central Scene Notifications to primary controller/gateway (In association group 1). In order to use Association
Groups, make sure that your gateway or software can allow you to set these (ie:
Vera Group Association Setup
(https://aeotec.freshdesk.com/solution/articles/6000162165-using-wallmote-quad-with-vera-ui7)), in order to do so, please
refer to your gateways manual on setting group association. This will allow the NanoMote Quad to directly
communicate ON/OFF or Dimming commands to your devices without going through your gateway.
Every control button also can send the control commands to control the devices in the other association groups, see
the table below:
Testing Health Connectivity.
You can determine the health of your NanoMotes connectivity to your gateway using a manual button press, hold, and
release function which is indicated by the LED color. This will help you maximize the battery life based on the health of
your NanoMote communication to your gateway.
Nano Mote Quad User Guide : Aeotec Group
https://aeotec.freshdesk.com/support/solutions/articles/6000184696-n...
To Next Page
Loading...
Need help?
General
