Aeotec TriSensor 8 - Product Usage


There are some placement considerations when using the TriSensor 8 as a motion sensor. Above are some diagrams that show the distance at which the wall or
ceiling installations can perform based on the height TriSensor 8 is installed, as well as the angle.
Ceiling installation should have at least 3m height to the floor for the most optimal motion detection.
Wall installation should have at least 2.5m height to the floor, angled downwards at 45 degrees.



The longer detection range of the motion sensor is in the direction of the side of the battery.

  Installation positioning advice:
Avoid installing TriSensor 8 in locations nearby environmental changes such as air conditioners, fans, or heaters. Instead, install the TriSensor 8 on the
opposite side of the room against environmental changes as these will greatly impact the temperature sensor if you wish to get the most accurate
temperature change for the overall room.
Make sure to avoid installing TriSensor 8 nearby any metal, metal has a property that reflects wireless signals which can greatly impact the range of this
sensor.
Ensure that there are no objects or obstacles in front of the sensor lens which can impact the motion sensor tracking.
Install TriSensor 8 pointed in the direction of the most foot traffic in the room.

Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the
devices of this network. This process is called Inclusion.
Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This
controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Inclusion
1. Set your Z-Wave hub to connect new Z-Wave devices.
2. Tap the TriSensor 8action button 3x times within 1.5 seconds.
3. If prompted, scan the QR code or enter the 5-digit DSK code.
Exclusion
1.Set your Z-Wave gateway into Z-Wave unpair(exclusion)mode.
2. Tap theaction button 3x times within 1.5 seconds; theredLED will light up.
Product Usage
Power up TriSensor 8.
TriSensor 8 can only be battery-powered, you must first power up your TriSensor before you can pair it and use it in your Z-Wave network.
