1. NOTES ON OPERATION
DEFROSTING THE OUTDOOR UNIT
When the outside temperature is low but there is
a high level of humidity, and the unit is operating
in Heating mode, the condensate formed on the
exchange surfaces of the outdoor unit tends to
freeze, reducing the heating capacity. The unit
control prevents this phenomenon by activating the
automatic defrosting function. When this function
is active, the fans of the indoor and outdoor units
could switch off and the unit could suspend the hot
air flow for a few minutes.
WARNING: During defrosting, the frost on the
outdoor unit melts and forms water: it is necessary
to provide an adequate water drainage system.
PREVENTING COLD AIR JETS
In Heating mode, ventilation on the indoor unit
is inhibited for a specific technical time to allow
the exchanger to reach the ideal temperature for
heating; it is therefore normal to notice a delay
between switching on the unit and activation of the
ventilation.
The delay can be noticed under the following
conditions:
1. Switching on Heating
2. After defrosting
3. Heating at low temperatures
16
5. UNIT TYPE
Indoor units in split-system air conditioners for
CONSOLE installation are designed to be installed on
walls indoors.
The air filter is easily accessible to enable regular
cleaning.
Air conditioners for CONSOLE installation are supplied
complete with a remote control.
Remote control
Remote control holder
Indoor unit
6. NOTES ON OPERATION
7. CHARACTERISTICS
• Console indoor unit for vertical installation.
• Operating mode: Cooling, Heating, Dehumidification, Automatic and Fan only.
• Timer programming switching on and switching off.
• Night-time comfort program (Sleep).
• TURBO function to attain the desired temperature as quickly as possible.
• Extended Ventilation Function (X-Fan / BLOW) during the Cooling and Dehumidification Mode prevents the
formation of mould in the indoor unit.
• Smart preheating function to prevent cold air jets (Heating Mode).
• Self-diagnostics function.
• Auto-Restart Function: The System will store the functioning status settings present before a sudden Black Out.
Once the Electric power supply is restored, the System will automatically resume operation in the previous
stored status.
• “Anti-freeze” function that allows you to keep an inside minimum temperature of 8°C in winter.
• ”iFEEL” function: it allows you to activate the ambient temperature probe inside the remote handset for greater
environmental comfort.
• Regenerative air filter.
• “Quiet” function for extremely silent running.
• Indoor Unit fitted with two inlets for an optimal control of the air flow and greater environmental comfort. One
air inlet is positioned on the top and the other on the bottom. By means of a special micro-switch, under the
front panel, it is also possible to set only the top inlet.
• Air ioniser (Cold Plasma Generator).
• Integrated WiFi Module Kit.
WiFi
To Next Page
Loading...
Need help?
General
