EasyManua.ls Logo

AERMEC CWX250W - Page 10

AERMEC CWX250W
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
LIQUID CRYSTAL DISPLAY


1 - TEMPERATURE (°C) OR (°F)

2 - OPERATING MODE
Shows the operating mode:
FAN ventilation
COOL cooling
DRY dehumidification
3 - SLEEP PROGRAMME
Shows the night comfort function SLEEP is active.
4 - TRANSMISSION INDICATOR
Appears every time a button is pushed and it indicates the transmission of the signal.
5 - FAN SPEED
Display of the three fan speeds and the automatic speed control:
AUTO automatic speed control
HIGH high speed
MED medium speed
LOW low speed
6 / 7 - TIMER
Indicates that the timer programmed on or off function has been activated.
8 - KEY LOCK
Shows the key lock function is activate.
9 - ION
Function not available
PREPARATION OF THE REMOTE CONTROL
Open the battery cover by pressing slightly in the direction of the arrow.
 
Close the battery cover.
IMPORTANT
The two control types, remote control, can be used at the same time on the same fan coil unit.
The batteries have an average life of 10 months when used normally.
The two batteries must be identical and must be changed at the same time.
Remove the batteries from the remote control unit if you envisage the units not being used for long periods.
When the remote control only works near the fan coil unit, it is time to replace the batteries.
Do not fix the remote control bracket near a source of heat or in direct sunlight. Avoid exposing the remote control to excessive

Do not place the remote control near electronic equipment because it could interfere with the unit's proper operation.
USE OF THE REMOTE CONTROL
Point the remote control transmitter towards the fan coil receiver while the settings are
being programmed.
To be able to carry out any operation or change of the settings from the remote control,
the unit must be powered.
When a signal is received correctly by the CWX_W it will emit a beep. If you do not hear
the sound, press the remote control button again.
Obstacles must not be placed between the transmitter and the receiver (e.g. furniture or

– The remote control is able to transmit effectively up to 7 metres from the fan coil unit
receiver.
1
2
3
4
5
6
7
8
9

Related product manuals