AERMEC DML 200 User Manual

19
CONDENSATE DISCHARGE
METHOD 1:
CONDENSATE DISCHARGE USING THE CONDENSATE
DRIP TRAY
1. Grasp the handles on both sides of the condensate
drip tray and remove it in the direction of the arrow.
During this operation, make sure not to spill water
onto the floor.
2. Empty the condensate drip tray.
3. Reposition the condensate drip tray.
METHOD 2:
CONDENSATE DISCHARGE DUE TO GRAVITY
1. Grasp the handles on both sides of the condensate
drip tray and remove it in the direction of the arrow.
During this operation, make sure not to spill water
onto the floor.
2. Insert the flexible condensate discharge hose (not
supplied) completely in the condensate discharge
connection.
3. Reposition the condensate drip tray.
4. Make sure that the condensate discharge hose is
positioned correctly and facing downwards. Be
careful not to crush the condensate discharge pipe.
condensate discharge
connection
condensate discharge
pipe
NOTE
Do not remove the condensate drip tray while the
unit is operating or if just turned off as this could
cause dripping.
NOTE
Use the condensate discharge hose if you do not
want to use the condensate drip tray.
Condensate discharge diameter (mm) Ø 14
condensate water
drip tray

AERMEC DML 200 Specifications

General

Brand	AERMEC
Model	DML 200
Category	Dehumidifier
Language	English