Need help?Do you have a question about the AERMEC MODUCONTROL and is the answer not in the manual?
General| Brand | AERMEC |
|---|---|
| Model | MODUCONTROL |
| Category | Control Unit |
| Language | English |
Identifies the functioning mode for the unit (Cooling or Heating).
Sets the work setting value active in cooling mode.
Applies a proportional band to the cooling set for compressor management.
Sets the active work set value in heating mode.
Applies a proportional band to the heating set for compressor management.
Activates work setting compensation based on outside temperature.
Defines cooling setpoints relative to outside air temperatures.
Defines heating setpoints relative to outside air temperatures.
Configures domestic hot water set and its proportional band.
Errors related to compressor magnet circuit breaker faults.
Errors related to fan magnet circuit breaker faults.
Errors detected by high or low pressure switches.
Errors from flow or water differential pressure switches.
Indicates issues with water inlet or outlet probes.
Alarm triggered when anti-freeze threshold is reached.
Errors related to pressing line gas temperature or cooling fin sensors.
Errors from flow pressure transducer or pressing line probe.
Excessive partialisation due to high pressure thresholds.
Excessive partialisation due to low pressure thresholds.
Partialisation triggered by pressing line temperature thresholds.
Errors related to Bemf detection or internal communication.
Errors indicating over-current, overload, or no load conditions.
Errors during start-up, IPM protection, or IGBT faults.
Errors related to EEPROM or lack of communication.
Errors indicating compressor stall or PFC module faults.
Errors for cooling fin overheating or DC Bus over-voltage.
Faults in the PFC converter or general software errors.
Errors due to overload, incorrect connection, or no communication.
Indicates a fault with the cycle reverse valve.
Alarm for exceeding the water inlet temperature parameter.
Cycle reverse triggered by high pressing line gas temperature.
Reading error of the DHW control board remote probe.
Faulty outdoor air temperature probe reading.
To Next Page
