Need help?Do you have a question about the AERMEC NRP 0700 and is the answer not in the manual?
General| Model | NRP 0700 |
|---|---|
| Category | Heat Pump |
| Power Supply | 400V/3Ph/50Hz |
| Refrigerant | R410A |
| Type | Air-to-Water |
Description of safety and control components, including pressure switches, transducers, and valves.
Overview of the electric control board, including transformer, fuses, contactors, and electronic controller.
Total pressure drops for system side cold water production in 2-pipe systems, with corrective factors.
Pressure drops for DHW recovery and 4-pipe hot water production, including corrective factors.
Total pressure drops for hot water production in 2-pipe systems, with corrective factors.
Graphs showing useful static pressures for low static pressure pumps in cooling mode (system side).
Graphs showing useful static pressures for high static pressure pumps in cooling mode (system side).
Static pressure curves for low static pressure pumps in DHW side (2 pipes) and heating side (4 pipes).
Static pressure curves for high static pressure pumps in DHW side (2 pipes) and heating side (4 pipes).
Criteria for selecting installation location, considering support surface, safety distances, and technician qualifications.
Table detailing recommended cable cross-sections, absorption values, and power supply information.
Procedure for unit start-up, including preliminary checks and operations when the unit is live.
Post-voltage supply operations, including checking power supply values and connections.
Checks for the cooling circuit, including compressor current, noise, voltage, and refrigerant leaks.
Verification of safety devices like high pressure switch and anti-freeze control.
To Next Page
