User Manual - URX_CF and URHE_CF -
4
Introduction
The controller is the compact device
that makes it possible to control units
for single-circuit air-to-air condition-
ing.
Pay special attention to the usage
regulations marked by the word
“DANGER” or “WARNING” or by the
“safety symbols“, as failure to respect
them may lead to harm to people
and/or damage to the machine/prop-
erty.
• For any problems not listed in this
manual, contact your local After Sales
Service immediately.
• The manufacturer cannot be held lia-
ble for any damage caused by the
improper use of the machine, or by
the partial or superficial reading of
the information given in this manual.
• Installation and maintenance must
be carried out by expert and quali-
fied personnel, according to the legal
requirements in force in the country of
installation for the electrical/electron-
ic as well as air conditioning installa-
tions. Failing this, the manufactures
declines any liability with regards to
the safety of the product.
THE MANUFACTURER DECLINES ANY
LIABILITY FOR DAMAGES TO PERSONS,
ANIMALS OR PROPERTIES CAUSED
BY THE FAILURE TO OBSERVE THE
INSTRUCTIONS AND REGULATIONS
INCLUDED IN THIS MANUAL.
Although during the design of the units,
an appropriate analysis of the risks was
carried out, pay ATTENTION to the picto-
grams on the machine that make reading
the manual easier by drawing the read-
er's attention on the situations posing
risks that cannot be avoided or sufficient-
ly limited by adopting protection meas-
ures and technical solutions.
GENERAL DANGER SIGNAL
Observe carefully all instruc-
tions next to the pictogram.
Failure to observe the instruc-
tions can lead to risk situations with
possible consequent damages to the
operator's and users' health in general.
DANGEROUS VOLTAGE SIGN
Observe carefully all instructions next to
the pictogram.
The sign shows the components of the
unit or, in this manual, identifies
actions that could cause electri-
cal risks.
GENERAL PROHIBITION SIGNAL
Carefully observe all instructions next to
the pictogram that limit some actions to
ensure greater safety for the operator.
MAIN WARRANTY
CONDITIONS
• The warranty does not include
the payment for damages due
to wrong installation of the unit by
the operator.
• The warranty does not include the
payment for damages due to improp-
er use of the unit by the operator.
• The factory shall not be liable for
incidents occurred to the installer
or user, arising from wrong instal-
lation or improper use of the unit.
The warranty is not valid only in case:
• services and repairs are car-
ried out by non-authorised
personnel and companies;
• the unit was previous-
ly repaired or modified with
non-original spare parts;
• no proper maintenance
was carried out on the unit;
• in case the instructions in this
manual were not followed;
• if non-authorised modifi-
cations were carried out.
N.B.:
The factory reserves the right to make
any changes in order to improve its prod-
ucts at any time, and is not obliged to
add these modifications to previously
manufactured machines, those that have
already been delivered or those under
construction.
Warranty conditions are in any case sub-
ject to the general sales conditions that
are in place when the contract is stipu-
lated.
To Next Page
Loading...
Need help?
General
