aero pure AP80RVL User Manual (English)

To Next Page

MODEL: AP80RVL

BATHROOM FAN

www.aeropurefans.com

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, PLEASE READ THE FOLLOWING:

CAUTION

1. For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. 2. This product is designed for installation

in ceilings up to a 12/12 pitch (45 degree angle). Duct connector must be horizontal. ** DO NOT MOUNT THIS PRODUCT IN A WALL.

3. To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit. 4. Please read

specification label on product for further information and requirements.

CLEANING & MAINTENANCE

For quiet and efficient operation, long life, and attractive appearance lower or remove grille and vacuum interior of unit with the

dusting brush attachment.

The motor is permanently lubricated and never needs oiling.

OPERATION

Use an on/off switch to operate this fan. See “Connect Wiring” for details.

PLAN THE INSTALLATION

1. Do not use in a cooking area.

2. Two ways to connect ductwork to a factory-shipped unit.

INSULATION*

(Place around and

ROOF CAP*

over Fan Housing.)

(with built-in

damper)

FAN

POWER

HOUSING

CABLE*

Keep duct

runs short

Seal gaps

around

Housing.

ROUND

DUCT*

WALL CAP*

Seal duct

(with built-in

* Purchase

joints with

ROUND

damper)

separately

tape.

ELBOW(S) *

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with the homeowner.

1.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number

listed in the warranty. 2.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power

from being switching on accidentally. If the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag,

to the service panel. 3. Installation work and electrical wiring must be done by a licensed person(s) in accordance with all applicable codes and

standards, including fire-rated construction codes and standards. 4. Sufficient air is needed for proper combustion and exhausting of gases through

the flue (chimney) of fuel burning equipment to prevent backdraft. Follow the heating equipment manufacturer’s guideline and safety standards such

as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning

Engineers (ASHRAE), and the local code authorities. 5. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden

utilities. 6. Ducted fans must always be vented to the outdoors. 7. Acceptable for use over a tub or shower when connected to a GFCI (Ground Fault

Circuit Interrupter) - protected branch circuit. 8. This unit must be grounded. 9. Never place a switch where it can be reached from a tub or shower.

10. Not for use in kitchens. 11. Install fan at least 2.5 m (8.2 feet) above the floor. 12. WARNING: To reduce the risk of fire or electric shock,

do not use this fan with any solid-state speed control device. 13. The fan must not be installed in a ceiling thermally insulated to a value greater than

R40.

Need help?

Do you have a question about the aero pure AP80RVL and is the answer not in the manual?

aero pure AP80RVL Specifications

General

Type	Exhaust Fan
Model	AP80RVL
Airflow	80 CFM
Duct Size	4 inches
Voltage	120V
Category	Fan
Frequency	60 Hz
Speed Settings	1
Material	Plastic
Features	Energy Star Certified
Power Source	Electric