MAINTENANCE MANUAL
ATC-600A-2
2-2-3
Page 1
Nov 1/05
3. Assemblies and Schematics
A. General
This section contains component layout drawings for all PC Board Assemblies, Interconnect
Diagrams and Circuit Schematics within the ATC-600A-2.
NOTE: Bubble call-outs correspond to items in the Parts List in Section 4.
B. How To Use Schematics
To trace coaxial cable conductors from one schematic to another, follow the procedure
outlined in para 2-2-3B(1) To trace conductors for multiple pin connectors, follow the
procedure outlined in para 2-2-3B(2).
(1) Coaxial Cables
STEP PROCEDURE
1. Locate desired assembly or module on Interconnect Diagram.
2. Locate desired coaxial cable on Interconnect Diagram.
NOTE: Connectors are identified by reference designators.
3. Follow coaxial cable on Interconnect Diagram to locate opposite end of
conductor. Note coaxial cable reference designator and destination.
4. Locate schematic of desired assembly or module.
5. Locate reference designator of coaxial cable and continue tracing circuit.
(2) Multiple Pin Connectors
STEP PROCEDURE
1. Locate desired assembly or module on Interconnect Diagram.
2. Locate desired multiple pin connector on Interconnect Diagram.
NOTE: Connectors are identified by reference designators.
3. Note reference designator of the mating connector. Note assembly, module or
wire harness, connector is mounted on or grouped with.
4. Locate schematic of desired assembly or module.
5. Locate reference designator of multiple pin connector and corresponding pin
number. Continue tracing circuit.
To Next Page
Need help?
General
