Aeroflex RGS-2000NG User Manual

TCAS Test Set
RGS-2000NG
Operation Manual
EXPORT CONTROL WARNING: This document contains controlled technical data under the
jurisdiction of the Export Administration Regulations (EAR), 15 CFR 730-774. It cannot be
transferred to any foreign third party without the specific prior approval of the U.S. Department of
Commerce, Bureau of Industry and Security (BIS). Violations of these regulations are punishable
by fine, imprisonment, or both.
Issue-6

Aeroflex RGS-2000NG Specifications

General

Brand	Aeroflex
Model	RGS-2000NG
Category	Test Equipment
Language	English

Summary

SECTION 1 - DESCRIPTION

1.1 DESCRIPTION

Provides a general overview of the RGS-2000NG TCAS Test Set and its capabilities.

1.2 FUNCTIONAL CAPABILITIES

Details the features and capabilities of the RGS-2000NG TCAS Test Set.

SECTION 2 - OPERATION

1. INSTALLATION

Provides instructions for installing the RGS-2000NG in a bench or rack environment.

1.2 SAFETY PRECAUTIONS

Outlines essential safety precautions for installation and operation of the RGS-2000NG.

3. RGS-2000NG SCREENS

3.1 SCREEN LAYOUT AND NAVIGATION

Describes the RGS-2000NG screen layout, including Main Display Area, Softkey Menu, and Status/Task Bar.

3.3 TCAS TEST MODE

Covers the TCAS system test functions, allowing selection of various test modes.

3.5 UAT TEST MODE

Details the selection of Settings, Receiving Station, Receiver, or Scenario Screens for UAT testing.

4. OPERATING PROCEDURES AND TEST CONFIGURATIONS

4.1 OPERATING PROCEDURES

Provides step-by-step instructions for various operating procedures and configurations.

4.2 TEST CONFIGURATIONS

Details various test configurations for ATC/Mode S/ELS/EHS, ADS-B Out, TCAS/Hybrid Surveillance, ADS-B In/CDTI, and TCAS Coordinated RA.

5. REMOTE OPERATION

5.4 BLOCK TRANSMISSION

Defines commands for setting up and transmitting blocks of messages to the UUT.

5.5 MEASUREMENT COMMANDS

Details commands for performing measurements on received signals from the UUT.

5.9 SCENARIO COMMANDS

Provides commands for defining dynamic and static intruders for TCAS scenarios.

SECTION 4 - SHIPPING

1.1 INFORMATION

Provides general information regarding the conditions for returning test sets to the factory.

1.2 AUTHORIZATION

States the requirement for authorization before returning products for service or repair.

1.6 REPACKING PROCEDURE

Details the steps for properly repacking equipment for shipment.

SECTION 5 - STORAGE

APPENDIX A - CONNECTOR PIN-OUT TABLES

A.1 I/O CONNECTORS - FRONT PANEL

Details the pin-out and I/O characteristics for the front panel connectors.

A.2 I/O CONNECTORS - REAR PANEL

Details the pin-out and I/O characteristics for the rear panel connectors.

APPENDIX B - METRIC/BRITISH IMPERIAL CONVERSION TABLE

APPENDIX C - ABBREVIATIONS

APPENDIX D - SDX COMPATIBILITY COMMAND SET TABLE

INSTRUMENT COMMANDS

Lists SDX instrument commands and their RGS-2000NG equivalents.

ATCRBS COMMANDS

Lists SDX ATCRBS commands and their RGS-2000NG equivalents.