3332
EPIC 2DEPIC 2DMaintenance
5.1 PUMPS STOP
EPIC 2D does not require any routine maintenance
provided that their working limits are observed.
Any maintenance operations must be performed
by qualified and experienced personnel, in
compliance withthe safety regulations in force.
5.2 SERVICE
DANGER!
Make sure that EPIC 2D is
disconnected from the power
supply before performing
any maintenance operations.
5.3 SPARE PARTS
Always state the exact model identification
number and construction number when
requesting technical information or spare parts
from our sales and service centre.
Use only original spare parts when replacing any
faulty components. The use of unsuitable spare
parts can cause malfunctions, personal injury
and damage to property.
5.4 WASTE DISPOSAL
After the control panel has been installed and
started, the customer must provide for the
appropriate elimination/disposal of the waste
materials according to the legislation locally
in force. If the control panel or parts of it must
betaken out of service and dismantled, follow
local regulations regarding sorted waste disposal.
Refer to the appropriate recycling centres.
CAUTION!
Contamination of the
environment with hazardous
substances such as battery
acid, fuel, oil, plastic, copper,
etc., may cause serious
damage to the environment
and endanger people’s health.
MODE
BUTTON STOP
MANUAL
MAN
The motor stops when the “MANUAL” button is
released or once you digit the 0 button.
AUTOMATIC
0
When the input commands are disable/non active once
you digit the 0 button.
OFF
Turning the main switch interlocking door in “OFF”
position.
Certifications
DECLARES UNDER IS OWN RESPONSIBILITY
THAT THE FOLLOWINGS CONTROL PANELS:
EPIC 2D -230 e EPIC 2D -400
ARE IN CONFORMITY
WITH COMMUNITY DIRECTIVES REGARDING:
AND AS APPLICABLE TO HARMONIZED STANDARDS:
Moreover Mr. Giuseppe Franchin, as the legal representative of the company, is the person authorized
to compile the technical documentation file.
Polverara - Italy, 10/01/2018
• European
directive
2006/95/CE
• Electromagnetic
compatibility
directive
2004/108/CE
• EN 61439-1
• EN 61439-2
• EN 60204-1
• EN 55014-1
• EN 55014-2
• EN 61000-3-2
• EN 61000-3-3
6.1 CERTIFICATE OF CONFORMITY
Technical Manager
(Giuseppe Franchin)
To Next Page
Loading...
