Aeware in.zone - In.zone; Warnings

2
in.zone
• Read and follow this manual carefully and make sure to save it
for later.
• This manual contains important information on in.zone's
installation, use and safety recommendations. It is your
responsibility to install and use your in.zone safely.
• Do not use in.zon
e if it is not connected to the spa system
(venturi) ; do not directly inhale ozone coming from in.zone.
Ozone can cause serious problems to your health.
• Do n
ot install in.zone outside of the spa equipment
compartment; it should be installed behind the spa skirt or panel
and protected against rain, sun, water hose or sprinkler, snow
and other outside elements.
• Install
in.zone above water level or as high as possible (as close
to water level as possible). Also install a check valve and make an
Hartford loop.
• In.zone m
ust be installed out of the bather’s reach.
• Make sur
e no water can get inside in.zone's enclosure. A check-
valve must be installed between the injection point and in.zone.
• Make sure
a suffi cient vacuum allows ozone to be injected
in water.
Warnings!
Important safety instructions
•
If in.zone is us
ed indoors, it must be in a ventilated room.
• Follow all el
ectrical codes required for this type of installation
and make sure all electrical connections are made by a qualifi ed
electrician.
• Use only electrical cord in good condition to power in.zone.
• In.zone must be
connected to a circuit protected by a ground
fault interrupter (GFCI).
• Mak
e sure all electrical power is off before installing or servicing
in.zone.
•
If in.zone
electrical connections are going through the spa
system
control, it is important that this control be protected by a GFCI.
•
In.zone s
hould be activated only when a pump creates a
suffi cient air vacuum.
• Never service an in.zone if you are wet.
• Do
not open the unit; there is no serviceable parts inside.
•
Disposal of the product:
the in.zone must be disposed of
separately in accordance with the local waste disposal legislation
in force.
warnings