2. Specific Tools for technicians
Standard tool box (wrenches, socket-head cap screw , hexagon keys, Phillips
(crosshead) tip and/or screwdrivers, etc.)
Voltmeter (To measure 24VDC)
Air pressure gauge (To measure 35 psi)
Batteries tester (under load)
Density meter
Valve Wrench
Wooden blocks to elevate the Breeze during checks, maintenance and repairs:
2 blocks 20-22 centimeters height to place beneath the batteries box.
2 blocks 14-16 centimeters height to place beneath the foot rest area.
Remark : Always before operating a lifted Breeze make sure that the 2 rear
wheels are free to turn , so that the scooters will not move.
3. Specific Parts:
We recommend the availability of the following set of test and repair assemblies:
1. Handlebars switches – Left and Right
2. Front Board
3. Display LCD Board
4. Main Harnesses Cable.
5. Main Lights Harness Cable.
6. Main Supply Harnesses.
7. Controller SDrive 140A - P&G
8. Motor/Power Unit
9. Also it is very much recommended hold and use P&G SP-1 Programmer (for S-Drive,
possible to upgrade old model to modified free of charge).
4. Options / Accessories assembling drawing /instructions
See attached accessories assembling drawing:
"Breeze S accessories1.pdf"
To Next Page
Loading...